Zanussi Heater Element location

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Zanussi Heater Element location

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • January 22, 2008 at 7:23 pm #33971
    robfin
    Participant

    Hi,

    Reading through the forums and I found that an error of AL3 on a Zanussi ZDI6895SX is most likely going to be the heating element.

    My question is, would it be the Flow-Thru Heater, and if so where can I get at it to test?

    Any help would be much appreciated.

    Robfin.

    January 22, 2008 at 8:41 pm #240723
    Penguin45
    Participant

    Re: Zanussi Heater Element location

    Remove r/h side panel.

    Power off…….

    Penguin45.

    January 22, 2008 at 8:53 pm #240724
    robfin
    Participant

    Re: Zanussi Heater Element location

    Got it out, what is the best way to test it?

    I have a multimeter, but don’t think it is the heater after looking at it. Should it be obvious if it is broken, i.e. burnt out connectors?

    January 22, 2008 at 9:11 pm #240725
    Penguin45
    Participant

    Re: Zanussi Heater Element location

    Tube heater – should read approx 25ohms.

    Pretty definitive discussion on Lux Group dishwasher heat problems here:
    http://www.ukwhitegoods.co.uk/modules.p … aeg+heater

    Penguin45.

    January 23, 2008 at 12:21 am #240726
    robfin
    Participant

    Re: Zanussi Heater Element location

    Wow! Good thread in that link.

    Thanks so much.

    Just after putting it back together after finding a dry joint and re-soldering it, everything back to normal…at least for a while!

    Thanks again. Great Forum.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.