Hotpoint WMA 30P ser no.82174792

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WMA 30P ser no.82174792

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • February 13, 2008 at 4:27 pm #34580
    robbra
    Participant

    Had to change door interlock but after this machine fills but no motor action. Brushes,taco all ok. On setting to any spin pump operates for couple of seconds then door lock light flashes fast stops then clicking from the pcb and door light flashes intermittantly.
    Using the last fault test proceedure in the fault code book it indicates just door lock.
    Any ideas please?
    Thanks.
    Rob

    February 13, 2008 at 4:39 pm #243220
    Martin
    Participant

    Re: Hotpoint WMA 30P ser no.82174792

    robbra wrote:Any ideas please?

    Module stuffed, but before you plug a new one in be sure that Interlock is changed AND that you look at the motor leads by the concrete weight. 😉

    February 14, 2008 at 8:53 am #243221
    robbra
    Participant

    Re: Hotpoint WMA 30P ser no.82174792

    Thanks Martin.
    Did the lock but never checked the cables.
    Rob

    February 14, 2008 at 3:44 pm #243222
    smart
    Participant

    Re: Hotpoint WMA 30P ser no.82174792

    I AGREE WITH ROBBRA. HAVE HAD A FEW WHERE WIRES HAVE RUBBED AGAINST THE CONCRETE AND BLOWN THE INTERLOCK AND SOME TRACKS ON THE P.C.B WHICH WAS EASILY REPAIRED WITH A LINK WIRE

    February 14, 2008 at 3:53 pm #243223
    robbra
    Participant

    Re: Hotpoint WMA 30P ser no.82174792

    Hi Smart.
    You are wrong, Martin is the clever one, robbra (me) is the thicko.
    Rob

    February 14, 2008 at 4:13 pm #243224
    smart
    Participant

    Re: Hotpoint WMA 30P ser no.82174792

    sorry new to the forums 😳

    February 15, 2008 at 10:52 am #243225
    robbra
    Participant

    Re: Hotpoint WMA 30P ser no.82174792

    Welcome Smart and enjoy it on here.
    You’ll see a lot of Martin, he’s a sort of father figure and pops up a lot on here
    Rob

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.