GW711 error code 9 (machine size)

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › GW711 error code 9 (machine size)

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 26, 2008 at 6:14 am #34861
    Andy-au
    Participant

    Hello !!

    i have a F&P GW711 machine which recently blew the motor controller PCB which i replaced with a new updated version.

    upon installing it, error code 9 appeared (00001001)

    i’m aware of how to enter diagnostics, but am unsure as to how to reset the machine size??

    please advise and thanks in advance!!!

    Andy-au

    February 27, 2008 at 1:26 am #244253
    Penguin45
    Participant

    Re: GW711 error code 9 (machine size)

    Press and hold Temp Up, then press Power. Wait for the 4 beeps, then:

    5/5.5kg machines – press Temp Up. Cold led should light.
    6/6.5kg machines – press Water Up. Low water led should light.
    7/7.5kg machines – press Spin Speed up. Spin hold led should light.

    Power off, try a programme.

    Penguin45.

    August 25, 2009 at 9:53 pm #244254
    blackduck
    Participant

    Re: GW711 error code 9 (machine size)

    Thanks Penguin
    hmmm was sent the instuctions on how to reset with the board,thought I followed correctly. Will do it again with your instuctions. I have contacted f&p and asked for a list of error codes. heres hoping
    Cheryl

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.