Hotpoint WF fault code.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF fault code.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 26, 2008 at 6:22 pm #34886
    Micky 32
    Participant

    Hi all. A customer just phoned and from the fault code she explained ( 1 and 3 light flashing) it’s a “pressure switch not sensing” code. She said it happens whatever she sets the machine at including spin. Will run for about 20-30 seconds and appear.

    Haven’t looked at the machine yet or have seen this code before, Is the pressure switch faulty or what’s causing it?

    February 26, 2008 at 8:20 pm #244331
    helo_75
    Participant

    just make sure you take an eprom and board

    obviously, check the sump, but its nearly always the pcb

    unless, of course the pressure switch has gone, but i think ive changed maybe 1 or 2 of them as opposed to 50 – 60 pcb’s

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.