- This topic has 4 replies, 2 voices, and was last updated 18 years, 1 month ago by
.
-
Posts
-
One for the Beko experts. 😉
Complaint of poor wash and timer jumping quickly through initial settings.
Set control to Prog 2, jumps through to just past 4, on Prog 10 it jumps just past 12.
Machine as clean as a whistle, Motor, heater NTC etc all look fine. At first I thought it could be sensing a faulty NTC and skipping the heat cycle but it will actually start to heat after it has skipped to 12, cannot get it to heat anywhere else.
I’m thinking timer unit, unless you know different. 😉
If it is the control unit does anyone have an idea of part number/cost?
Jim.
Re: BEKO WMB10W. Timer ??
Hi
Timer will advance to correct position, if you check user manual page 9.
“To start the programme , press the On/Off button The indicator will light and the closed door will be locked in a few seconds. The programmer knob will rotate and advance to the correct point to commence washing . This is a normal function of the programmer.”
Re: BEKO WMB10W. Timer ??
It will not stay on any settings for wash cycles, set it to 2 and it scrolls right past 3 & 4 before it stops, continues to fill and agitate.
That cannot possibly be correct function, or is it. 😕
Jim.
Re: BEKO WMB10W. Timer ??
Hi
Yes that is the correct function , the module controls the programming.
Mike
- You must be logged in to reply to this topic.