- This topic has 1 reply, 2 voices, and was last updated 18 years, 1 month ago by
.
-
Posts
-
Went to this dishwasher today, it the one that is similar to the Diplomat/Hygena models. It has 5 program lights in the top left of the door. When switching on it goes throught the normal start up ie drain out and takes water but not a full quantity. The machine then stops, and the first 3 lights in the door flash. I have checked the metering chamber and level tubes for blockages. Both the drain pump and circulating pumps are free to rotate.
I would appreciate any clues on this on. I don’t fancy changing the programmer at £100.
Cheers
Taff
Re: Smeg Dishwasher
Reset procedure for the PCB
With the door open, turn on the appliance and within three seconds push 4 times on the program selection
button – The test program has been selected if the SOAK and STRONG LED’s are flashing
This LED combination represents the test program for the appliances that have a flow meter.
If the above indication is not shown on the appliance, switch the appliance off and try the sequence again
until the above LED’s are shown on display.
Now push on the program button once more to select the version ‘without flow meter’, check that the SOAK
LED goes out, and the display is indicated as below.
Do not close the appliance door, to complete settings switch the appliance off.
Now switch the appliance ‘on’ and test on a SOAK program.
It is possible for this fault to exist on earlier models, if the appliance has had a PCB replaced with the latest
version. (earlier model are ADP8112 & 8132).
- You must be logged in to reply to this topic.