- This topic has 4 replies, 3 voices, and was last updated 18 years, 1 month ago by
.
-
Posts
-
hi i have a sevis 1300 model number m60035 my problem is,is my washer dose not spin properly ( i checked the washer with and without loads)it spins a few times then stops and dose a so called wash cycle in 5-10 mins and only spins say a few times +when i set to pump and spin it dose the same just spins a few times then stops dosent go intoa full speed spin,the water dose pump out oki.i was told it could be the brushes i checked these they seem fine still about a inch left on,also i was told it could be the pressure switch i removed this and when tried a wash it just filled the drum of water so i hooked it upto a multimeater to check the continuity i didnt get any readings on so called default position but when i blow into it i get a readings on all 1-2 2-3 -1-3 is this oki?i was also told it could be the main board? if u could give meany ideas of the problems i would be very greatfull thxxx
Re: SERVIS 1300 DOES NOT SPIN PROPERLY
Hi
Have you checked the pressure switch tube , ie: when you removed the hose from pressure switch you blew down the tube.
Posibly the pressure chamber on the sump hose underneath is blocked.Mike
Switch off and pull plug out before checking.
Re: SERVIS 1300 DOES NOT SPIN PROPERLY
MaD_FOr_iT wrote:i was also told it could be the main board?
Highly likely. So much so we walk into most Servis machines with one in hand. :rolls: 🙁
K.
Re: SERVIS 1300 DOES NOT SPIN PROPERLY
Washman wrote:Hi
Have you checked the pressure switch tube , ie: when you removed the hose from pressure switch you blew down the tube.
Posibly the pressure chamber on the sump hose underneath is blocked.Mike
Switch off and pull plug out before checking.
yer i checked the pipe blow down it ect seemed fineRe: SERVIS 1300 DOES NOT SPIN PROPERLY
do u know if my presure switch is oki though going of my continuity test i didnt get any readings on so called default position ( only on plug 4-2but u dont use plug 4)but when i blow into it soft i get a readings on 2-3 but when i blow hard i get readings on all plugs 1-2 2-3 -1-3 ( it dose have 4 plugs but it only uses 3 wires)is this oki??
- You must be logged in to reply to this topic.