Hotpoint WF860 completing program & starting again !!

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF860 completing program & starting again !!

  • This topic has 5 replies, 5 voices, and was last updated 18 years ago by M1.
Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 14, 2008 at 9:26 pm #35299
    M1
    Participant

    Hi

    Hotpoint WF860

    Customer complaining it’s completing program & then starting again !!

    Everything else works fine (no fault codes seen by customer, I know that means nothing as most would not know what one is if it bite them on the Bum !!) 😆

    Any ideas ??

    Thanks

    March 14, 2008 at 9:28 pm #245926
    lerch
    Participant

    Re: Hotpoint WF860 completing program & starting again !

    PCB & EPROM ❗

    March 15, 2008 at 12:27 am #245927
    M1
    Participant

    Re: Hotpoint WF860 completing program & starting again !

    Thanks Lerch your a star !! 😆

    March 15, 2008 at 11:45 am #245928
    admin
    Keymaster

    try first http://www.ukwhitegoods.co.uk/modules.p … ic&t=12044

    March 16, 2008 at 9:30 pm #245929
    HotDog
    Participant

    Re: Hotpoint WF860 completing program & starting again !

    this machine can start part of the prog again if it has completed the prog to soon – had same fault. does it do complete prog again or does it just extend time? if so there is no fault

    March 17, 2008 at 12:23 pm #245930
    squadman
    Participant

    Re: Hotpoint WF860 completing program & starting again !

    I had this, turned out the sump was blocked:

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.