- This topic has 4 replies, 2 voices, and was last updated 18 years ago by
.
-
Posts
-
This machine has worked without any problem for 6 years. Virtually every time we used the machine we would use the normal cycle selection (No.2 ) The machine would make a sort of humming noise for a little while and then you’d hear the water coming in.
Recently when you start the cycle there is a sort of crunching /crackling noise over the hum until the water comes in and then it sounds like it always has.
Any suggestions on what this could be?
Thanks
Re: Bosch SGS 3062 GB/02 FD 8109
Maybe something in the drain pump area.
Access is by removing filters and looking at the LHS of the sump recess to locate a torx 20 screw.
Remove the cover that, that screw is holding and see if anything is in there that shouldn’t be.
Bearing in mind it may be glass ❗Greg
Re: Bosch SGS 3062 GB/02 FD 8109
Cheers. Removed the cover as you described. No glass but found a tiny mushroom shaped piece of plastic. Removed that and the machine is quiet again.
Just out of interest – should this area be full of water?
Many thanks for your assistance
Re: Bosch SGS 3062 GB/02 FD 8109
Glad you sorted 😀
Answer to your question is yes but should be below the filters and just above that inspection plate; when in an empty state 😉Greg
- You must be logged in to reply to this topic.