Beko dishwasher not heating

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko dishwasher not heating

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • March 18, 2008 at 3:33 pm #35388
    pete-c
    Participant

    Model no DE3542FS not heating water.Have metered in line heater OK. Checked voltage input to heater found to be between 40 and 50 volts.

    Peter

    March 18, 2008 at 5:16 pm #246374
    Seamy
    Participant

    Re: Beko dishwasher not heating

    Have got report of same problem, going tomorow to check, let you know how i get on.

    March 18, 2008 at 6:10 pm #246375
    Madmac
    Participant

    Re: Beko dishwasher not heating

    Heater relay on pcb would be worth a sniff methinks. 😉

    March 19, 2008 at 9:43 pm #246376
    SWERV
    Participant

    Re: Beko dishwasher not heating

    possible dry joint on board.
    Merv

    March 20, 2008 at 8:21 am #246377
    blackandwhites
    Participant

    Re: Beko dishwasher not heating

    IN THE PAST IVE HAD THIS PROBLEM AND YES THE PCB HAS SOMETIMES BEEN AT FAULT.I HAVE ALSO HAD A SNAPPED WIRE TO HEATER IN THE BOTTOM END OF THE DOOR AND ALSO FAULTY THERMISTOR ,ATTACHED TO SIDE OF SUMP.—STEVE

    March 20, 2008 at 8:02 pm #246378
    Seamy
    Participant

    Re: Beko dishwasher not heating

    There is a service/diagnostics mode for this machine.
    Its hard to understand because its a bad translation from Turkish.
    My interpretation of it is:–

    Switch off machine, select program 2, hold in start button & keep it held for 3 secs.
    All indicators should come on for 2 secs’.
    Release & press start button again.
    Machine will run short diagnostic program, drain, fill, circulation, regen, detergent,heating to 65C, circulation again, pump out.
    Press start button

    faults will be shown by indicators:-
    No indicators = no fault
    Wash led = water inlet fault
    End led = NTC fault
    Both leds = Heater fault

    if all indicators blink it also means no fault

    March 21, 2008 at 12:24 am #246379
    bubs
    Participant

    Re: Beko dishwasher not heating

    Did one today,
    The same 12v coil, 5 pin relay used on electrolux and some merloni.
    The pcb is very cheap if you don’t have the relay -about £20- nice to see Beko pricing things so we can get the repairs.
    Graeme

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.