F&P fault 9

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › F&P fault 9

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • April 4, 2008 at 5:07 am #35746
    tdrake7
    Participant

    Hi can you please help me ? I believ this is my fault .F & P fault 9

    April 4, 2008 at 5:53 am #247894
    bigsmokepiker
    Moderator

    Re: F&P fault 9

    MODEL WOULD HELP
    If its a washer 9 is a size error

    April 4, 2008 at 6:29 am #247895
    tdrake7
    Participant

    Re: F&P fault 9

    thank you , yes its an old washer., how do I correct the fault.

    April 4, 2008 at 10:15 pm #247896
    bigsmokepiker
    Moderator

    Re: F&P fault 9

    Model Number please

    April 4, 2008 at 10:44 pm #247897
    Penguin45
    Participant

    Re: F&P fault 9

    tdrake7 wrote:Hi can you please help me ?
    I have a Fisher & Paykel washing machine Model No MW058U
    Error 9

    From duplicate thread (deleted).

    Penguin45.

    April 4, 2008 at 11:26 pm #247898
    Penguin45
    Participant

    Re: F&P fault 9

    Size error. To set size for your machine:

    Press and hold Temp Up, then press Power. Wait for the beeps, then press Temp Up again. Cold LED should light to set for 5kg. Power off, then try running it.

    Penguin45.

    April 5, 2008 at 1:28 am #247899
    tdrake7
    Participant

    Thank you , Iv done that and now I have fault 11.

    April 6, 2008 at 3:42 pm #247900
    Penguin45
    Participant

    Re: F&P fault 9

    Water level control problems – the transducer readings are incorrect. the sensor unit is part of the main pcb, so you may be looking at replacing it.

    Has there been work carried out on the machine recently?

    Penguin45.

    April 6, 2008 at 11:37 pm #247901
    tdrake7
    Participant

    Re: F&P fault 9

    Thank again, Iv been reading through many old posts and am starting to understand how thes smart machines work, as an aprentice I did washing machine repairs 40 years ago.Now i picked some machines up and are changing parts to reawaken a couple of washers. so yes i need to know some fault codes. at present 116 + 104 also does the size correction aply to all resizing, regardless of model? I have yellow , blue ,and green mudules.

    April 9, 2008 at 11:40 pm #247902
    Penguin45
    Participant

    Re: F&P fault 9

    This is actually a lot more complicated than you may realise……. Your 058 is a phase 4 machine – only a yellow board will fit and function corrrectly when the correct size is set. There are different procedures for different load machines, and different phase machines.

    116 is not a recognised code. 104 is a communications error between the display board and the motor board. Possible causes are the display board, pump, rotor position sensor or combinations of them.

    Penguin45.

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.