- This topic has 0 replies, 1 voice, and was last updated 17 years, 12 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
The ready light is flashing on, nothing else works I have swapped the PCB & it fires in to life. I have tried the following reset method for other Beko model WMA 1751s, just wondered if there is a different reset method for this model. Thanks
Turn power button off (not at wall)
Select 90 degree wash
Press Start and Cancel button down at same time for 3 seconds and turn power button on whilst still holding buttons down – Start light will flash.
Leave power on.
Select any Spin position.
Press Start and Cancel button at same time again for 3 seconds – other buttons may start to flash – if they do, press Start and Cancel button together again for 3 seconds.
Machine should be re-set ready for use.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.