whirlpool ADG7340 dishwasher ‘F7’

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › whirlpool ADG7340 dishwasher ‘F7’

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 14, 2008 at 12:32 pm #35995
    mike100
    Participant

    ‘F7’ code on dishwasher = flow meter failure.
    Does this part have to be replaced and what does the flow meter do?.
    Has anyone else had experience of this fault code and is it remedied by replacing the flow meter?
    the spare part no is: 481227128407 switch diaphram

    April 14, 2008 at 6:32 pm #249061
    Penguin45
    Participant

    Re: whirlpool ADG7340 dishwasher ‘F7’

    Flow meter is part of fill chamber on LH side – 4812 418 68147. Replacement not always required – a clean of the contacts and a squeeze will often get it working again.

    The flow meter has a magnet in it which passes by a reed switch. As it spins, the computer counts the rate and number of pulses generated.

    Chris.

    April 24, 2008 at 5:35 pm #249062
    mike100
    Participant

    Re: whirlpool ADG7340 dishwasher ‘F7’

    sorry for delay in replying as customer been on hols.
    Thanks for info. Did as you suggested and it works perfectly now.
    Couldn’t find any gunge in flow meter. It may just have been that taking it out and cleaning did the job.
    Thanks once again penguin.
    Mike

    April 24, 2008 at 8:53 pm #249063
    Galway
    Participant

    Re: whirlpool ADG7340 dishwasher ‘F7’

    had one of these last year and there was a slight kink in fill hose .didnt go near flow meter and seemed to sort problem.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.