Hotpoint washer dryer WD420

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint washer dryer WD420

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 23, 2008 at 5:46 pm #36242
    neptune
    Participant

    Customer complained of no heat on dryer. Changed the thermostat on top of heater duct, as it was open circuit. To change this it is necessary to take the top off the heater box. Machine worked ok on test, Called back today, same problem, stat failed again. No obvious obstructions, fan working, water appears at drain hose when pump operates. Anyone got any ideas on this please?

    April 23, 2008 at 6:29 pm #250175
    helo_75
    Participant

    does it have the fluff filter on the heater box?

    if it has, rip it off and disconnect the flushing valve

    April 23, 2008 at 6:31 pm #250176
    boselecta
    Participant

    Re: Hotpoint washer dryer WD420

    cant you just reset the stat with a pin? Is it the dryer unit with the tumble dryer style filter? does that need cleaning. Also is there water going to the condensing unit via the filter unit?

    April 23, 2008 at 7:21 pm #250177
    roy1
    Participant

    Re: Hotpoint washer dryer WD420

    I have had the same problem in the past, now when i get
    a cutout failure i always change the thermistor.

    April 23, 2008 at 10:15 pm #250178
    S1MON
    Participant

    check the filter on the top of the tub and also ive had a few were the fans have come loose and not turned

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.