Hotpoint WF430

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF430

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 25, 2008 at 8:45 am #36278
    Mark1
    Participant

    This machine starts to fill then some of the lights and the on/off light flashes. You then cant turn the machine off unless you fully disconnect power. Is this a new board fault and are they expensive? Thanks 😕

    April 25, 2008 at 9:35 am #250312
    iadom
    Moderator

    Re: Hotpoint WF430

    Which lights start to flash? Make a note of them by number from the top down and check them in the ‘Known Error Codes’ thread first.

    Jim.

    April 28, 2008 at 9:42 am #250313
    Mark1
    Participant

    Re: Hotpoint WF430

    looks like lights 2,3 &4 which I think would be the heater relay. I presume this means a new board? Sometimes it works for a couple of washes before it happens again. Any other possibilities?

    Mark

    April 28, 2008 at 10:24 am #250314
    iadom
    Moderator

    Re: Hotpoint WF430

    A strong possibility the PCB is faulty but I would be checking the contacts and tightening ( squeezing) all the connector blocks on the PCB first.

    Jim.

    April 28, 2008 at 10:54 am #250315
    Mark1
    Participant

    Re: Hotpoint WF430

    Will try connectors 1st.
    Thanks.

    M 🙂

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.