GW708 fault codes memory

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › GW708 fault codes memory

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 9, 2008 at 1:58 pm #36621
    qualos0
    Participant

    Hi, I’m new to this forum and have read somewhere in amongst the many reported defects that the F&P fault codes stay in the memory for 8 wash cycles.

    How can the fault codes be cleared without waiting for the 8 wash cycles?

    Thanks

    May 9, 2008 at 11:16 pm #251735
    bigsmokepiker
    Moderator

    Re: GW708 fault codes memory

    Dont know what you read but SHOULD BE
    If washer APPEARS TO HAVE A FAULT .The fault would have occured WITHIN the last 8 wash cycles

    If you have a problem with washer run the diagnostics thru the sticky above

    May 10, 2008 at 8:53 am #251736
    qualos0
    Participant

    Re: GW708 fault codes memory

    Thanks for the information. I had fault code 50 (hot water valve) which I fixed, however the fault code is still showing when I run the diagnostics.

    I’m assuming the fault code will clear itself in 8 wash cycles, however I was hoping there was a procedure to clear fault code in the memory without waiting for the 8 wash cycles.

    Thanks

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.