DWF B10 blinking

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › DWF B10 blinking

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 11, 2008 at 10:19 pm #36667
    cherrytree
    Participant

    Hi,
    I have a Whirlpool DWF B10 dishwasher and up till now has been working OK, but I had to move it to repair a leak in the pipework. Now when I tried to use it, it seems to be working then after about a minute stops and it starts to bleep until you open the door. And it also starts to flash/blink 6 times, then a pause and then 6 more times, any ideas please because I have no idea wht is going on. Also I do not have the manual to see what the problem may be!
    Any help would be useful to me.

    May 11, 2008 at 10:53 pm #251881
    Penguin45
    Participant

    Re: DWF B10 blinking

    No fill detected in the time allowed. You’ve almost certainly not turned the water on properly – those horrid little blue plastic levers sometimes turn through 90 degrees and don’t turn the tap bit on. Or, you’ve nipped the fill hose over when you shoved it back.

    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.