Tecnik / Neff SE6TIE2GB/42

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Tecnik / Neff SE6TIE2GB/42

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 14, 2008 at 8:22 pm #36732
    RickT
    Participant

    Just fitted new heater (483257) to this one. On testing the water level just about reaches the underneath of the filter. All hoses and fill chamber are cleaned. Machine starts to fill as normal but then cuts off before the diaphragm switch is activated. Suspect the lack of water circulating was the cause of the heater blowing. Suspect the usual pcb. Any clues would be much appreciated.

    May 14, 2008 at 8:32 pm #252121
    Penguin45
    Participant

    Re: Tecnik / Neff SE6TIE2GB/42

    Hose in the bottom left lower corner will be choked – if it’s bad it can back up into the pressure/fill chamber. Cleaning usually sorts it.

    Chris.

    May 14, 2008 at 8:40 pm #252122
    RickT
    Participant

    Re: Tecnik / Neff SE6TIE2GB/42

    Thanks Chris. However straight after this post I checked on machine’s progress and is now working fine (filling up to base of salt cap). I’ve stripped the guts out of this one and totally cleaned every orifice and hose in there. I shall keep a check on this and report back if any probs.
    Cheers Rick

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.