- This topic has 6 replies, 2 voices, and was last updated 17 years, 11 months ago by
.
-
Posts
-
Hi
I have a diplomat dishwasher (not sure of make as its built it.
It does a cycle but does not drain the water fully. Comes up with E3 code. If we turn on and off it eventually drains. Had someone look at it and sorted out the waste pipe as there was problem with that but its still doing it. Would it be the water outlet system in the middle at the bottom?
any advise would be apreciated – many thanks
Re: e2 code
Model number please, Lisa – on the label down the edge of the door.
Which code are you getting – 2 or 3?
Penguin45.
Re: e2 code
hi will check model number when get in later.
error code 2
did get a 7 at one point but that has gone away!
Re: e2 code
Safety pressure switch has been activated; the main level switch has not been activated. This can be caused by sludge build-ups, failure of the main level switch or by a potty computer board.
Complex appliance and diagnosis can be difficult to get right – I would suggest pro help – use the repairs@ link on the left for a repairer in your area.
Penguin45.
Re: e2 code
hi thanks for this. Just read my first posting and in eror I put e3 code when in fact it was a e2 code – does this mean the same thing….
- You must be logged in to reply to this topic.