- This topic has 5 replies, 4 voices, and was last updated 17 years, 10 months ago by
.
-
Posts
-
Called to the above Indesit complaint not working.
Tested the machine, no fault found. Advise customer to use machine and check which LEDs flash if the problem reoccurs.
Called back following day (no surprise) an told ‘easy iron’ LED flashes and slight noise and what appears to be something blowing the washing.
Returned to the customer and found as the customer says. When set to start the pump runs for about 5 seconds, stops then restarts followed by the second LED flashing ten the dryer fan starts up while the LED flashes. If I press the off switch the machine restarts and continues flashing and blowing.
I have metered out the machine and checked the connections on the PCB.
Has anyone else come across this, I’m assuming it’s going to be a board change.
erm, have you checked the dryer ntc?
thats the usual suspect on one of those, and they aint dear either
Re: Indesit WIDL102UK LED2 & dryer fan comes on!
F04 Press sw jammed on empty, either pressure sw, blockage press chamber hose or duff module hope this helps cheers JJ.
Re: Indesit WIDL102UK LED2 & dryer fan comes on!
johnnyj wrote:F04 Press sw jammed on empty, either pressure sw, blockage press chamber hose or duff module hope this helps cheers JJ.
Didn’t think it would be the pressure switch jammed on empty as the machine didn’t attempt to fill. If it was jammed on empty I thought it would have overfilled then given the error.
I didn’t check the dryer NTC, would this have given the F04 error and made the dryer motor run as it did? What resistance should I expect across the NTC?
Re: Indesit WIDL102UK LED2 & dryer fan comes on!
It’s not a “logical” fault, so almost certainly PCB.
Chris.
- You must be logged in to reply to this topic.