hotpoint belt fitting tool

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › hotpoint belt fitting tool

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • June 11, 2008 at 10:17 am #37310
    abbots
    Participant

    hi,
    i’ve seen various posts about this but i can’t seem to find them-sorry if i’m going down old ground here.

    belt fitting tool for HPT/ind dryers , connect part number 5045170988043

    is it any good?is it obvious how to use it when you get one?
    i’m fed up of struggling to get the 1860H9 hpt TD belts on, and thought this might make life easier, can any one give it the thumbs up or is it a waste of £35

    thanks guys.
    john

    June 11, 2008 at 10:24 am #254371
    iadom
    Moderator

    Re: hotpoint belt fitting tool

    The tool is only for vented dryers but it makes the job a complete doddle. The end slots into a hole the base and two small arms go over the belt which you then lever down and over the pulleys, takes seconds.

    THIS is the thread you are looking for, there is a picture of the tool on page #3.

    Jim.

    June 11, 2008 at 11:38 am #254372
    Alex
    Participant

    Re: hotpoint belt fitting tool

    Here’s a tip on fitting Crosslee belts, and should work on the Creda ones.

    Get yourself a Tricity Bendix oven door handle, 3116132006 (comes as a pair). Pull off one end cap/piece, and then the hollow end put over the motor shaft as you “roll” the belt along into place. The remaining end piece/cap (which will be in your hand) you use to rotate the belt into place.

    Alternatively use a long-reach socket on an extension.

    Alex

    June 11, 2008 at 12:15 pm #254373
    abbots
    Participant

    Re: hotpoint belt fitting tool

    cheers guys.
    jk

    June 11, 2008 at 3:13 pm #254374
    iadom
    Moderator

    Re: hotpoint belt fitting tool

    I’m sure Martin will concur that once you haved used the Hotpoint special tool nothing else comes anywhere near it for of ease of use.

    Well worth the money. ( even if I had mine made for me at no cost ) 😉

    Jim.

    June 11, 2008 at 3:20 pm #254375
    Martin
    Participant

    Re: hotpoint belt fitting tool

    iadom wrote:I’m sure Martin will concur that once you haved used the Hotpoint special tool nothing else comes anywhere near it for of ease of use.

    ‘Tis true…… it was ever thus….. without my special tool I’d be lost for a purpose it’s fair to say 😉 8)

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.