hotpoint CTD00

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint CTD00

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 14, 2008 at 12:38 pm #37385
    MDE
    Participant

    New front fan fitted, now there doesn’t seem to be enough air circulating through the drier, both fans are turning, can not find any blockages, element cover to hot to touch, a lot of condensation on inside of door and in drum, drum turning clockwise looking at it from the front. Any suggestions please.

    Mark.

    June 14, 2008 at 10:11 pm #254705
    lerch
    Participant

    Re: hotpoint CTD00

    check the condensor, is it clear and cleaned. Also check the front felt bearing duct to see if still attached otherwise air could be escaping from drum.

    June 16, 2008 at 12:08 pm #254706
    MDE
    Participant

    Thnks for your reply lerch.I found out customer had a go before calling someone out to look at the drier and he put the back fan back on back to front, so that’s what restricted the flow of air through it.
    Mark.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.