Hotpoint WD860 P

This topic has 6 replies, 4 voices, and was last updated 17 years, 9 months ago by rocker.

Viewing 7 posts - 1 through 7 (of 7 total)

Author

Posts
June 28, 2008 at 9:32 am #37718

rocker
Participant

fault on this machine, child lock light flashing unable to set up any programes, fitted main PCB from emw.
now the interlock won’t engage, fitted new lock same fault, 240v going into lock. checked cables into pcb for o/c. also tightened & refitted all push in plugs.

any ideas please. John

June 28, 2008 at 9:56 am #256155

helo_75
Participant

u checked the brushes?

June 28, 2008 at 10:19 am #256156

rocker
Participant

Re: Hotpoint WD860 P

helo.
Not yet, but will do now, thanks for advice. John

June 28, 2008 at 6:03 pm #256157

rocker
Participant

Re: Hotpoint WD860 P

looked up connect web site no motor brushes listed, picture of motor has no visual bush holders showing , does this mean new motor if brushes shot !!!
John

June 28, 2008 at 6:20 pm #256158

Penguin45
Participant

Re: Hotpoint WD860 P

3 phase motor – no brushes…..

Chris.

June 28, 2008 at 6:35 pm #256159

iadom
Moderator

Re: Hotpoint WD860 P

John, I’ve sent you some ‘stuff’ 😉

Jim.

June 28, 2008 at 8:05 pm #256160

rocker
Participant

Re: Hotpoint WD860 P

Chris & Jim, thanks for your help, Jim received the tec info.
cheers John
Author

Posts

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.