Beko WMA665W not washing

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #37730
    bubs
    Participant

    Hi,
    Have a Beko WMA665W machine to repair. It Fills, then no motor action.
    After a few mins, the rinse light flashes (3rd from top) and the pause light comes on. If you set it to spin, it works fine, distribute and spin.

    I ran the self test in the UKWG book, first time; all ok, second time; no motor action on the wash speed test. Again it spun fine.
    Have checked motor brushes, assume main pcb, any other ideas?

    Thanks
    Graeme

    #256195
    Dales-Electronic
    Moderator

    Re: Beko WMA665W not washing

    Tacho at back of motor – these are available as a spare part.

    #256196
    bubs
    Participant

    Re: Beko WMA665W not washing

    Thanks, will go back and have another look.

    It puzzles me why there is no jump in speed when you try a spin prog, distributes fine. I an still learning Beko stuff…

    Graeme

    #256197
    neptune
    Participant

    Re: Beko WMA665W not washing

    By a strange coincedence, I had a similar fault today, Went to a Beko, no model number to hand. the fault was that on wash, the drum would tun several times at spin speed, and then abort so to speak. On stripping The tacho, the magnet fell off in 2 pieces. the magnet appears to be moulded around a brass knurled collar which is then pressed onto the shaft. Anyone know if the magnet/collar is available as a seperate part?

    #256198
    bubs
    Participant

    Re: Beko WMA665W not washing

    Just an update, went back to check tacho, all looked and metered fine. Had a good look a pcb, again nothing obvious.
    Tested on wash and then it all worked fine, could not fault. On Test!!
    Graeme

    #256199
    robbra
    Participant

    Re: Beko WMA665W not washing

    I was lost on one like this with the same lights showing and it was the heater. Strange because one minute it meggered ok then after a test was o/c.
    Rob

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.