Hotpoint TDC30P

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint TDC30P

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 8, 2008 at 12:27 pm #37952
    subs
    Participant

    Hi

    This Dryer had a broken drive belt, but there also seems to be a lot of
    movement in the drum. You can push the drum back slightley from the front and it drops down a fraction from the front support assembly.What would i need to do to solve this? I see they do a front support assembly complete and rear seal. May not be cost effective. Any advice please.

    Thanks

    Subs

    July 8, 2008 at 5:20 pm #257224
    Phidom
    Participant

    Re: Hotpoint TDC30P

    You often need to pack out the rear bearing spindle with washers to push the drum forward. If there’s a washer behind the bearing you can put it in front.

    July 11, 2008 at 9:41 pm #257225
    subs
    Participant

    Re: Hotpoint TDC30P

    Thanks Phidom.
    Done this today and it done the job.(Although it was a bit difficult to get the split pin back in)

    Subs

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.