INDESIT WIL163S – NTC FAULT?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › INDESIT WIL163S – NTC FAULT?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 10, 2008 at 9:20 pm #38025
    Minge
    Participant

    Hi..

    I have this appliance where according to UKWG fault code manual the error code indicates an ntc or module fault?

    My querie is that straight away after a cycle the appliance constantly drains and fills at the same time whilst giving this error, prompting me to think its a module fault as i would think the ntc doesnt come into play until it is full of water?

    Please advise!!

    July 10, 2008 at 9:57 pm #257443
    neilsukwg
    Participant

    Re: INDESIT WIL163S – NTC FAULT?

    I havnt read the manual but can confirm that a replacement ntc has worked both times I have had that fill/mt fault.

    One of those actually worked after I merely removed and cleaned up the connection to the ntc.

    July 10, 2008 at 11:16 pm #257444
    Penguin45
    Participant

    Re: INDESIT WIL163S – NTC FAULT?

    Classic board fault is select, start, constant fill and drain. NTC unlikely to be involved. Had one this very afternoon doing this – removing the pcb showed the tracks to the triac array burnt, causing cross feeding to the pump triac.

    Hoik it out and have a look. Triac failure in its own right can cause the problem but may not be visible.

    Chris.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.