- This topic has 5 replies, 3 voices, and was last updated 17 years, 8 months ago by
.
-
Posts
-
Do someone had worked on these machines? because beside of being too many peripherals (shock absorber sensor/ flow meter/ analogic pressure switch / aqua clean sensor), DC motor board and also big display… isn’t anything else but sh…
On pushing power button “ON” display it’s activated and appear one big “Siemens” logo and that’s all… At few seconds periond (two or third) display and power led’s are disconnected for a fraction and restarting logo… I have measured voltage on user interface board isn’t stopping…
Do have someone info for this kind of machine?
PS. after few attempts have had lucky to see it working. I have run one spinning program OK but, after switching OFF and ON 👿 again on initial stage….
8) baron
Re: Siemens WIQ1430/01
Me brother (BSH engineer) has replaced lots of PCB’s on them.
When I asked him which one, of the three, he said…
“Dunno, I just replaced them all!”
Ps, that m/c should have a 10year guarantee with Siemens?
Re: Siemens WIQ1430/01
Goatboy wrote:Me brother (BSH engineer) has replaced lots of PCB’s on them.
When I asked him which one, of the three, he said…
“Dunno, I just replaced them all!”
Ps, that m/c should have a 10year guarantee with Siemens?
Nice 😯 😡 🙁
and what can we do? garbage???PS. this machine has arrived like second-hand without qurantee from Germany (perhaps it was one of returned from the market because is like new) … and want to be repaired…
Re: Siemens WIQ1430/01
Hi
“Siemens” displayed / no function
Analogue sensor outside the operating range
Check cable to analogue sensor. If required, replace analogue sensor or module.HTH
Greg
PS – You have email 😉
- You must be logged in to reply to this topic.