- This topic has 1 reply, 2 voices, and was last updated 17 years, 9 months ago by
.
-
Posts
-
Hi
I have an issue with my whirlpool 7550 where it stops through a cycle and leaves a load of waste water in the bottom under the dishes. The start button flashes 4 times then pauses.
I can reset it and sometimes it will work for a couple of washes.
I guess this could be something to do with the drain pump as the evacuation pipe is clear of blockages, or do you think there could be a blockage elsewhere, or dodgy pump?
Any help would be much appreciated.
Kind regards Steve.Re: Whirlpool ADG 7550 fault light flashes 4 times.
Four flashes is no drain detected in the time allowed. As you have water in the machine, you have a blockage somewhere (always worth checking the sink coupling, if applicable) or a failing pump. It’s a twist fit under the front if wish to investigate.
Power off, first.
Penguin45.
- You must be logged in to reply to this topic.