Zanussi FX1365W short spin.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi FX1365W short spin.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 5, 2008 at 9:16 pm #38561
    aqualectric
    Participant

    Zanussi FX1365W. PNC:- 9149251100.

    Fault reported: short spin cycle; washing is not spun enough.
    Diagnostics show no faults, although during the cycle all the vertical LEDs flash then the start LED flashes. Cycle continues as normal. This is sporadic and doesn’t happen every time. Sometimes during drain and sometimes during spin. 😕
    The water drains, the motor ramps up through the 4 stages of spin to 1300 revs. Total time spinning – 2 minutes max. Then the cycle ends as normal and the door unlocks. The washing is spun about as good as an 800 spin.

    I am thinking PCB is at fault – any help on this please??

    Thanks,

    Steve.

    August 5, 2008 at 10:52 pm #259292
    leavemetogetonwithit
    Participant

    Re: Zanussi FX1365W short spin.

    Sounds as if it might be intermittently draining too slowly due to coin or similar blocking pump/hose sometimes. Though this would not explain short spin duration ❓
    Mike.

    August 7, 2008 at 10:38 pm #259293
    aqualectric
    Participant

    Re: Zanussi FX1365W short spin.

    Thanks for the reply, Mike.

    Anyone else have a suggestion?

    Steve.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.