Zanussi zdt6053

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi zdt6053

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • August 11, 2008 at 5:47 pm #38678
    timjam
    Participant

    Hi i replaced the pcb on this last week due to faulty on/off switch fitted on the pcb, cust rang to say that its now not “hot!” at the end of cycle and there are suds left in it. I have been back out today and the dishwasher doesn`t seem to be heating, only have 68v to element. I refitted old pcb with on/off switch bridged to rule out faulty pcb but stilll have the same fault. I am about to order thermister, does anyone think this may be the cause ?
    Regards Tim

    August 11, 2008 at 6:20 pm #259640
    Penguin45
    Participant

    Re: Zanussi zdt6053

    Heater’s just fed by a loop from A1 to D4. NTC is on a separate circuit. Got to be board or wiring?

    Chris.

    August 11, 2008 at 6:39 pm #259641
    timjam
    Participant

    Re: Zanussi zdt6053

    unless i have a connection wrong!! do u have wiring chart for the pcb?

    August 11, 2008 at 7:11 pm #259642
    BobHope
    Participant

    Re: Zanussi zdt6053

    Hi Timjam,
    pm sent.

    Bob.

    August 11, 2008 at 7:20 pm #259643
    Cras
    Participant

    Re: Zanussi zdt6053

    Ahh! By Gadd! What you need Tim, is a little book to write things down in!!!
    *puff on pipe*
    lol

    August 11, 2008 at 9:03 pm #259644
    timjam
    Participant

    Re: Zanussi zdt6053

    unless i have a connection wrong!! do u have wiring chart for the pcb?

    August 11, 2008 at 9:08 pm #259645
    Penguin45
    Participant

    Re: Zanussi zdt6053

    Sent.

    Chris.

    August 11, 2008 at 11:16 pm #259646
    timjam
    Participant

    Re: Zanussi zdt6053

    thanks
    😆

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.