iNDESIT WIL163 WASHING MACHINE

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › iNDESIT WIL163 WASHING MACHINE

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • August 13, 2008 at 11:42 am #38721
    IP
    Participant

    Hi, got a indesit WIL163 washing machine, any program that its put onto, runs for about 10seconds, then just runs the water valve and the drain pump at the same time, the iron and rinse lights flash ( light 3 + 4 from left ) and the red door lock light flashes every second ??
    Any ideas, everything looks like ok, ive been suggested that its the control pcb gone faulty?

    August 13, 2008 at 8:09 pm #259770
    helo_75
    Participant

    f03

    not sensing ntc

    could be the ntc probe (in the heater), but experience would suggest pcb failure

    hope this helps!

    February 6, 2009 at 3:48 pm #259771
    mjw1208
    Participant

    Re: iNDESIT WIL163 WASHING MACHINE

    Got same fault on a WIL163 but had pcb checked by EMW – No fault found and changed NTC but still water fills and drain pumps water out after 1 minute or so ,anybody got any other suggestions ? thanks

    February 6, 2009 at 3:53 pm #259772
    iadom
    Moderator

    Re: iNDESIT WIL163 WASHING MACHINE

    You have trade access mjw1208, best to ask your questions on ‘The Dark Side’ 😉

    Jim.

    February 6, 2009 at 4:10 pm #259773
    mjw1208
    Participant

    Re: iNDESIT WIL163 WASHING MACHINE

    The dark side ? is that t’other side of pennines ?

    February 6, 2009 at 4:26 pm #259774
    iadom
    Moderator

    Re: iNDESIT WIL163 WASHING MACHINE

    To quote the Oldham Tinkers from their song Owdham Edge,

    ” An now wi cum ter Yorkshurs line, a can’t si nowt past theer but grime” 😛 😆

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.