Smart Drive 058 – Will not engage (#00101011=43)

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Smart Drive 058 – Will not engage (#00101011=43)

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • August 18, 2008 at 7:21 am #38811
    nlxon
    Participant

    F & P Smart Drive 058 – It will not engage for filling or spinning, just jolts as it attempts to rotate, the touch pad seems ok and is functioning.

    After the machine has finished attempting to start any cycle it starts beeping and the (from Left to Right) third and last green light stay on and the second yellow and red spin lights are also on. (00101011 – I think?)

    What is wrong???? How can I fix it!!!

    Model: MW058K

    August 18, 2008 at 8:26 am #260059
    Penguin45
    Participant

    Re: Smart Drive 058 – Will not engage (#00101011=43)

    Out of balance switch faulty. Remove top deck for access – switch suffers from corrosion and soggy wiring. Also check bias spring is located on tub and casing.

    Penguin45.

    August 18, 2008 at 8:34 am #260060
    nlxon
    Participant

    Re: Smart Drive 058 – Will not engage (#00101011=43)

    Thanks, I have done this and yes the switch is rooted, I have replaced the out of balance switch and she’s running like a dream!

    Thanks Mate!

    October 20, 2008 at 6:21 am #260061
    Spyder
    Participant

    Re: Smart Drive 058 – Will not engage (#00101011=43)

    Hi I’ve got a GW509NZ with the same fault code. It won’t fill, just goes in short burts for 5-6 tries then beep, beep with the 00101011 fault code. Is this the same problem as discussed here?

    If so, what is involved in removing the top deck for access??

    Cheers, Spyder

    October 20, 2008 at 6:41 am #260062
    bigsmokepiker
    Moderator

    Re: Smart Drive 058 – Will not engage (#00101011=43)

    YEP Fault Code 43
    Possibly OUT of Balance Micro switch
    Power OFF
    Control Panel Has Screws at Rear
    Panel Tilts Forward
    Switch Sits Under Main PCB On RHS

    October 20, 2008 at 6:35 pm #260063
    Spyder
    Participant

    Re: Smart Drive 058 – Will not engage (#00101011=43)

    Great. Have explored and seen the switch. Will try and buy a replacement today. How does it come out?

    October 21, 2008 at 6:07 am #260064
    bigsmokepiker
    Moderator

    Re: Smart Drive 058 – Will not engage (#00101011=43)

    Have to take out motor controller (Main PCB)
    Straight Foward From there

    October 22, 2008 at 5:23 am #260065
    Spyder
    Participant

    All fixed and up and running again.

    Big thanks to the website and bigsmokepiker in particular 😀 :tup:

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.