Gert big Bosch problem:(

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Gert big Bosch problem:(

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • August 19, 2008 at 10:48 am #38848
    Martin
    Participant

    A Bosch WBB24759GB/01 monster 10kg machine in fact, not pumping. But the pump is OK and there is a live feed to in but no neutral from it back to the module. My problem is not knowing how the hell I can access the control module? 🙁

    It would be handy to have a service manual that details how to access the front and top panels as it seems far from obvious to me. 😳

    Also a wiring chart would be handy as these beasts have 2 modules but the pump appears to be controlled by the module at the top rather than the power module in the base?

    The programme display doesn’t show any error warning either and it will do a full 19 minute spin only cycle without showing a fault at all – very odd! 😕

    The heater is fine as is the motor but can’t access the rest.

    Hope you can help me please? 🙂

    August 19, 2008 at 11:11 pm #260171
    leavemetogetonwithit
    Participant

    Re: Gert big Bosch problem:(

    https://www.bosch-eshop.com/eshop(bD1lbiZjPTAwOQ==)/bosch/gb/prodp.htm?prod=WBB24759GB{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}2f01
    Exploded diagram. HTH?
    Mike.

    August 19, 2008 at 11:30 pm #260172
    Penguin45
    Participant

    Re: Gert big Bosch problem:(

    Link is just the options page, Mike.

    Chris.

    August 20, 2008 at 7:29 am #260173
    Martin
    Participant

    Re: Gert big Bosch problem:(

    Thanks for the info Greg, much appreciated. 😀 😉

    August 20, 2008 at 1:24 pm #260174
    leavemetogetonwithit
    Participant

    Re: Gert big Bosch problem:(

    Penguin45 wrote:Link is just the options page, Mike.

    Chris.

    Funny, I checked it before posting.

    August 20, 2008 at 1:58 pm #260175
    Martin
    Participant

    Re: Gert big Bosch problem:(

    leavemetogetonwithit wrote:Funny, I checked it before posting.

    Mike,

    When you say “exploded diagram” do you refer to a wiring diagram or just the spare parts illustration?

    August 20, 2008 at 11:38 pm #260176
    leavemetogetonwithit
    Participant

    Re: Gert big Bosch problem:(

    Just the spare parts illustration.
    If you found that exploded diagram,I would have thought that 4 screws (0108) covered by 4 caps (0109) would get the fascia off. Then you go to page 4 to find wirng harness to pump (0435).
    HTH, Mike.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.