Hotpoint D/W FDW20 Type LS12-EVO3

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint D/W FDW20 Type LS12-EVO3

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 20, 2008 at 1:50 pm #38890
    silverbroom
    Participant

    Power to on/off but otherwise nothing, no other lights, no reset,
    everything else checks out ok.

    Visually PCB looks fine as does programme selector so PCB it is or can you tell me more?.


    thanks silverbroom

    August 20, 2008 at 2:46 pm #260261
    Martin
    Participant

    Re: Hotpoint D/W FDW20 Type LS12-EVO3

    PCB every time, the usual BIT 100 module fault involving power relay I would think?

    August 21, 2008 at 3:08 pm #260262
    silverbroom
    Participant

    Re: Hotpoint D/W FDW20 Type LS12-EVO3

    Thanks for that Martin, I note that on the Connect site it lists 2 boards what other info do I need to end up with correct one.

    silverbroom.

    August 21, 2008 at 3:20 pm #260263
    Martin
    Participant

    Re: Hotpoint D/W FDW20 Type LS12-EVO3

    silverbroom wrote:Thanks for that Martin, I note that on the Connect site it lists 2 boards what other info do I need to end up with correct one.

    Ah yes, much deep joy over this is to be had indeed, typical Indesit :rolls:

    Before serial no: 41011.000 you need C00143211
    After serial no: 41011.001 you need C00144314

    So check out the serial number!

    All the best 😉

    August 21, 2008 at 4:50 pm #260264
    silverbroom
    Participant

    Re: Hotpoint D/W FDW20 Type LS12-EVO3

    Thanks Martin for the prompt reply, I’m old enough to know that the serial number would have played a part.

    Three years from retirement can’t come soon enough.


    silverbroom

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.