Hotpoint WD71

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WD71

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • September 4, 2008 at 8:41 pm #39236
    mike412
    Participant

    Hi Guys.

    Could a kind person please help me out with a wiring diagram for this machine?
    Did a straightforward bearing change today, done loads in the past no problems. Carried out a wet test on reassembly, found the machine heating on the rinse programme. Heater and wiring all ok, only wiring I had reason to touch was the plug with ribbon cable to the facia panel/module so I guess must be something to do with that. Did not have time to resolve today, going back Tues, would like to be as prepared as possible.

    Many Thanks in anticipation,

    Regards,
    Mike

    September 4, 2008 at 9:43 pm #261773
    grazzamongrel
    Participant

    Re: Hotpoint WD71

    i would check the valves and heater as i have had both cause strange faults on tis appliance, but i would put my money on a faulty heater down to earth. the ribbon you describe is purely for the display mod and wouldnt cause any faults apart from losing the display.

    HTH :rolls:

    graham

    September 4, 2008 at 10:05 pm #261774
    mike412
    Participant

    Re: Hotpoint WD71

    Hi , Thanks for that.

    This was my first thought , but the heater meggers up fine. It will probably end up being something silly.

    Cheers, Mike.

    September 5, 2008 at 6:01 am #261775
    mike412
    Participant

    Re: Hotpoint WD71

    I ommitted to say that on pump and spin it was still heating. Just thought I would add this little snippet of info to bring this post back up to the top of the pile!.

    Any assistance much appreciated.

    Regards,
    Mike

    September 5, 2008 at 7:41 am #261776
    Martin
    Participant

    Re: Hotpoint WD71

    I can only imagine the heater relay on the power board jammed maybe? 😕

    September 5, 2008 at 8:06 am #261777
    grazzamongrel
    Participant

    Re: Hotpoint WD71

    yep that would be my next thought power board probs. 😉 😯

    September 5, 2008 at 9:42 am #261778
    iadom
    Moderator

    Re: Hotpoint WD71

    Mike, check your e-mails. 😉

    Jim.

    OOPS, sent it to wrong person. 😳

    September 6, 2008 at 11:26 am #261779
    grazzamongrel
    Participant

    Re: Hotpoint WD71

    shabba

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.