Servis M6500s

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Servis M6500s

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 8, 2008 at 3:11 pm #39315
    PGS
    Participant

    Called to above today, firstly it will not allow you to cancel prog by selecting stop. When selecting a rinse /spin prog it does a full wash. I meggered motor and heater and hung a pump on. Now is it it the prog selector or pcb?
    Any help appreciated.

    September 8, 2008 at 3:54 pm #262014
    timdowning
    Participant

    Re: Servis M6500s

    I would say selector at fault. Sometimes if your lucky you can carefully take selector apart and clean contacts.

    September 8, 2008 at 5:24 pm #262015
    robbra
    Participant

    Re: Servis M6500s

    I would vote for the module…had quite a few like this. Janus so you would need the kit to programme unless you had it from EMW.
    As ever the serial no. is very helpful on Servis m/c
    Rob

    September 8, 2008 at 5:35 pm #262016
    timdowning
    Participant

    Re: Servis M6500s

    If you change the main module on the Janus type the front pcb will program the main module once you switch on the machine. (as long as the Janus module hasn’t been programmed before, as in returned stock back to servis etc).

    This model could be both types, Janus or pre-Janus.

    I still would put money on it being the selector though.

    September 8, 2008 at 6:42 pm #262017
    robbo1973
    Participant

    Re: Servis M6500s

    changed tonnes of selectors on these for this kind of fault if you select stop to reset and it doesnt move the dial really slowly either way and you will find it resets change the selector and all will be well again.

    cheers chris

    September 8, 2008 at 6:54 pm #262018
    PGS
    Participant

    Re: Servis M6500s

    Should i order both. Also how do i tell if its Janus or not, will Servis know from serial number.

    September 8, 2008 at 8:03 pm #262019
    robbo1973
    Participant

    Re: Servis M6500s

    tell cust to open filter flap if there are a series of 2 digit numbers down the side of the sticker it is janus if not it aint.personally i would do just selector as i have changed loads

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.