Indesit WD12X f05

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Indesit WD12X f05

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 9, 2008 at 2:27 pm #39341
    doobatron
    Participant

    My machine has given up and is displaying the F05 fault.
    The machine will not empty.
    I’ve checked the filter – no blockages, impellor moves round freely
    I’ve checked the outlet pipe – no blockages there.
    I’ve checked the large black pipe underneath the machine – no blockages there.

    The motor seems to be quite hot though.

    Could it be that the pump is actually broken?

    Any other problems likely to cause these symptoms?


    Thanks for your kind attention.

    September 9, 2008 at 3:27 pm #262183
    helo_75
    Participant

    f05 is pressure switch stuck on full

    usually, its a blocked pump
    f11 is failure to activate pump, so quite possibly, it just needs a new pump

    September 9, 2008 at 6:23 pm #262184
    doobatron
    Participant

    Re: Indesit WD12X f05

    Thanks for taking time to reply Helo_75.

    My machine is a WD12X although it doesn’t say it is a WD12XUK am I correct in assuming it is as I purchased it in the uk?

    If not a WD12XUK will the below piece fit my WD12X anyhow?

    http://shop.ukwhitegoods.co.uk/Washing+ … +Pump.html


    Thankyou.

    September 9, 2008 at 7:11 pm #262185
    helo_75
    Participant

    like all pumps, the rear of the pump unit would definatley transfer over, but an email to spares@ on the link below will supply you with the correct pump

    the correct model number is written on a sticker on the inside of the door, on a sticker around the door seal

    are you not able to use a multimeter to confirm the pump is dead?

    September 10, 2008 at 7:54 am #262186
    doobatron
    Participant

    Re: Indesit WD12X f05

    No I dont have use of a multimeter so would have to risk the part.
    However the pump is getting prettyhot, so I assume power is getting to it but it isnt working, does this sound feasable?

    Thanks for the info re ordering new part.

    September 10, 2008 at 4:46 pm #262187
    helo_75
    Participant

    if its getting hot, yes the power is there, so a new pump should cure it

    good luck

    September 11, 2008 at 6:22 am #262188
    doobatron
    Participant

    Re: Indesit WD12X f05

    Thankyou.

    I shall try it and let you know how I got on.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.