Zanussi ZWF1621W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZWF1621W

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 12, 2008 at 3:51 pm #39438
    S1MON
    Participant

    ZWF1621W

    914521005/01

    This machine was showing a E45 fault and cutting out mid wash. The fault guide said problem with the doorlock side of the PCB. Therefore I replaced the PCB and doorlock to be sure.

    Now it is showing a motor fault E54? Ive tested the motor it runs fine on the test program but will stop mid wash and the start button will flash? Ive tested all components and nothing points me in the right direction. What are the boards on these like, is there a common reason for failure.

    M/C is only 18 months old

    Cheers

    September 20, 2008 at 6:33 pm #262421
    S1MON
    Participant

    just an update on this the motor comm was down under load so new motor did the trick , thing is only 18 months old!!

    September 21, 2008 at 6:38 am #262422
    Phidom
    Participant

    Re: Zanussi ZWF1621W

    Motor failure is usually down to overloading which can happen any time in the life of a machine. I had one customer who destroyed 2 Hotpoint motors within a week.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.