Candy Washer Dryer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Candy Washer Dryer

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 15, 2008 at 3:20 pm #39502
    oscar123
    Participant

    I have just been to a Candy CMD136-80 Washer Dryer, it is not filling on main wash but it will fill on a synthetic cycle. The machine starts the programme and the drum turns but no water enters. The customer being a marine electronics wiz ordered and fit a new control module but it made no difference and he had the same fault.

    I have tried a new dryer module, checked all crimped connections, the machine uses the same valve on synthetic wash as it does on main wash so I am stuck for ideas where to look, can anybody give me a clue. Pressure switch seems to have two levels clicks once and then switches at max.

    September 15, 2008 at 3:30 pm #262631
    Martin
    Participant

    Re: Candy Washer Dryer

    oscar123 wrote: can anybody give me a clue.

    I’ll send you the test routine pdf file….check your email (2 separate ones in fact) directly 😀

    September 19, 2008 at 9:48 am #262632
    oscar123
    Participant

    Re: Candy Washer Dryer

    Many thanks Martin, it turned out to be a faulty heating element. new one in and sorted. It wouldn`t of been the last place I would of looked but not far from it!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.