E90 fault zanussi ZWF143S

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › E90 fault zanussi ZWF143S

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 22, 2008 at 4:32 pm #39664
    jenson
    Participant

    Hi i have a zannussi zwf143s giving a e90 fault 1 have the tds offline disc but no mention of fault E90 any info would be appreciated Jenson

    September 22, 2008 at 4:52 pm #263145
    bazza500
    Participant

    Re: E90 fault zanussi ZWF143S

    Off the top of my head….. E90 is not draining.

    September 22, 2008 at 4:58 pm #263146
    DentedPorsche
    Participant

    Re: E90 fault zanussi ZWF143S

    Hiya,
    E90 is an error code shown to the customer.
    Go into diagnostics and you’ll get an engineer code when you look up the last stored error.
    In general it’s a communication error.

    Brian

    September 22, 2008 at 6:16 pm #263147
    bazza500
    Participant

    Re: E90 fault zanussi ZWF143S

    Just looked it up and Brian is right I was talking complete drivel…. 😳

    September 22, 2008 at 6:17 pm #263148
    mbdas
    Participant

    Re: E90 fault zanussi ZWF143S

    Hi 🙂 Its on my tds 😆 its normally the blue wires between the command panel and the main board hope that helps 🙂 9.3 Notes about some alarms
    �� Configuration alarms
    �� E91: the error is indicated by the flashing of all the LEDs, E90 is displayed on the display, if
    featured.
    �� E92: the error is indicated by the flashing of the LEDs placed over the buttons, E90 is displayed
    on the display, if featured.
    �� E93: the error is indicated by the flashing of the phase/warning LEDs, E90 is displayed on the
    display, if featured.


    mark 🙂

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.