LG bearings..pig of a job??

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › LG bearings..pig of a job??

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 22, 2008 at 5:47 pm #39665
    Madmac
    Participant

    Have a WM16110fd needing new ones. Having not had the pleasure before, was wondering if anyone has any tips , any special tools needed ? Thanks, Eddie.

    September 22, 2008 at 6:00 pm #263149
    mbdas
    Participant

    Re: LG bearings..pig of a job??

    HI 😀

    nice easy job I would sooner do one of these anyday over a zanussi bearing job 🙂 1 hr 15 mins my personel best 🙂 I always change the tub half seal as well 🙂

    Mark 🙂

    Lucky Goldstar

    September 22, 2008 at 7:01 pm #263150
    Madmac
    Participant

    Re: LG bearings..pig of a job??

    Ok Mark, i will go for it then! It does look good for access, stripping the motor assembly off was what was worrying me, nuffin me lump hammer cant solve im sure.. thanks for response. 🙂

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.