Schulthess 6kg filling when finished

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Schulthess 6kg filling when finished

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 24, 2008 at 8:14 am #39714
    Seamy
    Participant

    Schulthess 6kg semi commercial machine, fills when programme is finished, when isolator is shut off it stops so obviously its not a leaking valve. Anyone have any info on these?
    I remember this machine from being at it before & it has a large control board mounted under the worktop & an electronic type pressure sw’.

    Thanks in advance.

    September 25, 2008 at 7:35 am #263312
    Lawrence
    Participant

    Re: Schulthess 6kg filling when finished

    Sounds like the chopper module (one on top) Expensive piece of kit
    Try James Armstrong 0163533881 .
    Lawrence

    September 27, 2008 at 11:03 am #263313
    Seamy
    Participant

    Re: Schulthess 6kg filling when finished

    Update, 12v solenoids on this machine feed from top board, hot water valve has supply to it all the time (even when machine is finished programme), when all other outputs are taken off board only when front board disconnected, user/display board unconnected will it lose the supply, not certain if its a front board or top board fault. Top board lists at £500 so you can see why i need to be sure.

    Wondering if machine can be reprogrammed to fill from cold only as machine is fed only by cold water albeit to two hoses using a Y piece, it obviously defaults when in hot/warm washes when pipe to hot valve isn’t connected..

    September 27, 2008 at 7:32 pm #263314
    spanner51
    Participant

    Re: Schulthess 6kg filling when finished

    I have some service info on these machines. I dont know how to send with a P M , so if you post your email I will try to send it to you

    Graham

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.