Bosch SRS43A02GB/14 CB Programing

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch SRS43A02GB/14 CB Programing

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 24, 2008 at 6:44 pm #39725
    Twoten
    Participant

    I had a call to the above machine due to not drainng, machine had foamed up and couldn’t pump the foam. While there the customer complained that the quick wash took a lot longer than stated in the instructions, and always had.

    I ran a test and found when put on a quick wash the machine still goes through the pre-rinse which it shouldn’t do. The only thing I can think would cause this is if the control board is incorrectly set up changing the function of the selection buttons.

    Does anyone know which LED’s should be lit when setting up, at the moment it’s L2 + L4.

    The buttons on this machine are:
    l Normal l Eco l Quick Wash l Pre-rinse l

    The control board should be part number 489716.

    Any help would be appreciated.

    September 24, 2008 at 10:03 pm #263353
    nomadPaul
    Participant

    For the model and buttons you’ve put down , it should be coded to 1 which will be LED 2 only lit.

    September 25, 2008 at 7:55 am #263354
    Twoten
    Participant

    Re: Bosch SRS43A02GB/14 CB Programing

    Thanks nomadPaul,

    I assume you mean the first of the three visible LED’s and L3 + L4 off?

    September 25, 2008 at 8:43 pm #263355
    nomadPaul
    Participant

    i’m pretty sure that right mate.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.