Beko WMA 610S rinse light on

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko WMA 610S rinse light on

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 25, 2008 at 1:27 pm #39745
    neptune
    Participant

    Went to this machine today. On switching on machine, the rinse light is permanently lit, and the start/pause button is illuminated. The door locks, and without pressing start, the pump starts and runs for about 3 seconds. then nothing. Same on all progs. checked heater, sol valves, nothing obvious. Any ideas? Thanks in advance.

    September 25, 2008 at 1:55 pm #263410
    robbra
    Participant

    Re: Beko WMA 610S rinse light on

    Have you checked the brushes?
    Had one last week. In situ perfect circuit but were worn right down.
    Rob

    September 25, 2008 at 3:07 pm #263411
    neptune
    Participant

    Re: Beko WMA 610S rinse light on

    I did check brushes in situ with multimeter. Would worn brushes cause the rinse light to stay lit?

    September 25, 2008 at 5:42 pm #263412
    robbra
    Participant

    Re: Beko WMA 610S rinse light on

    I’ve had them on Beko to do many strange things like stopping the programme at a point and not allowing a reset, just pumping or setting prog,doing one tumble and lights all flashing. The one last week had great continuity in situ but were down to the minimum and only 2 years old.
    Rob

    September 25, 2008 at 6:43 pm #263413
    neptune
    Participant

    Re: Beko WMA 610S rinse light on

    Many Thanks for that . will look tomorrow.

    September 25, 2008 at 7:31 pm #263414
    lerch
    Participant

    Re: Beko WMA 610S rinse light on

    After checking carbons I would be checking the pcb – changed loads.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.