Whirlpool AKZ350 Oven Fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool AKZ350 Oven Fault

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 26, 2008 at 11:46 am #39765
    beno
    Participant

    This oven was originally dead. I replaced the main power board but there is now a fault code displayed. F03. In the whitegoods fault code book it says that the power board is not configured-replace board. It is a new board on the appliance.
    Does anyone know how to configure the new power board?

    September 26, 2008 at 12:25 pm #263512
    bzz67
    Participant

    Re: Whirlpool AKZ350 Oven Fault

    521 0 4812 214 58379 Power unit Basic SAM
    521 0 4812 214 58562 Power unit programmed

    this is from the whirlpool site, looks like you may have the unprogrammed

    September 26, 2008 at 3:36 pm #263513
    beno
    Participant

    Re: Whirlpool AKZ350 Oven Fault

    Thanks for the info but neither part number is coming up in our spares database. Can you give me the link where you found this info??

    September 26, 2008 at 4:18 pm #263514
    bzz67
    Participant

    Re: Whirlpool AKZ350 Oven Fault

    sorry just had another look, going to need service number next, there are a few different ones

    September 27, 2008 at 7:02 am #263515
    beno
    Participant

    Re: Whirlpool AKZ350 Oven Fault

    The service number is 858535015000.
    Thanks.

    September 27, 2008 at 7:57 am #263516
    bzz67
    Participant

    Re: Whirlpool AKZ350 Oven Fault

    481221478894 Control unit GEMINI 2
    this the correct part number, but it dosnt say if its configured or not.

    F03
    CAPRICORN not properly
    configured
    Replace CAPRICORN

    it only says this about the fault. tells you to replace and not configure!!

    September 29, 2008 at 7:33 pm #263517
    Alanj
    Participant

    Re: Whirlpool AKZ350 Oven Fault

    Beno

    there should have been a configuration sheet in the box with the module.

    Alan

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.