servis m6725w three flashes

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › servis m6725w three flashes

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • October 6, 2008 at 2:01 pm #39992
    dealdd
    Participant

    have got a servis m6725w with no power. i found a blow on modual so replaced from ewm. fitted board and still had problem so replaced user control board as well. still no joy all that happens is you get three lights flashing from the start button, you cant reset it or start programme. has any one got a clue what the three flashes mean???

    October 6, 2008 at 2:41 pm #264402
    Washman
    Participant

    Re: servis m6725w three flashes

    Hi

    This machine has the Janus module part no 546089200 . So has to be reprogramed with the Janus hand held unit, if you replace the display unit.

    Mike

    October 8, 2008 at 1:04 pm #264403
    dealdd
    Participant

    Re: servis m6725w three flashes

    how do you do this ???

    October 8, 2008 at 3:05 pm #264404
    bazza500
    Participant

    Re: servis m6725w three flashes

    If you`re not an agent and don`t have the Janus palm terminal then you can`t.

    October 9, 2008 at 12:56 pm #264405
    dealdd
    Participant

    Re: servis m6725w three flashes

    so if the control board is blowen its a write off

    October 9, 2008 at 1:16 pm #264406
    Washman
    Participant

    Re: servis m6725w three flashes

    Hi

    This machine might have been covered by the free five years parts guarantee.

    Mike

    October 9, 2008 at 1:39 pm #264407
    Lawrence
    Participant

    Re: servis m6725w three flashes

    If you fit a Jenas to a m/c the top board programmes it ,if the top card has blown as well then as everyone says the hand held terminal is req ,but a thought ? all the new Jenas modules come unprogrammed ,your module from EMW may have been repaired but may be programmed for a different model so you will have a conflict between the two .
    Lawrence

    October 9, 2008 at 2:55 pm #264408
    bazza500
    Participant

    Re: servis m6725w three flashes

    Good point Lawrence

    October 9, 2008 at 3:22 pm #264409
    timdowning
    Participant

    Re: servis m6725w three flashes

    We’ve had this discussion before;

    What was the part number of the board fitted? was it 546089200?

    If its is the above module then I would say either its a wiring problem or the module fitted has been programmed with the wrong information.

    On the left side of the module you should have 2 blocks of connectors. The way I remember the wiring of these is there should be 4 of the gold contacts unused at the top.

    On the top of the board you have 2 more connectors. One with two wires and one with 8 I think?? I’m sure its the longer connector on the left then the smaller connector on the right??

    If its a programming fault then you will either need an unprogrammed module or the Janus hand held unit to re-do the tag insertion.

    The wiring is from my memory!!!!!!!!!

    October 10, 2008 at 12:41 pm #264410
    dealdd
    Participant

    ok guys thanks for help

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.