Indesit IDL530UK2 No Heat -Dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit IDL530UK2 No Heat -Dishwasher

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 8, 2008 at 7:19 am #40046
    Latham63
    Participant

    Element and cut out ok.Small leak from element fixing detected which had been tripping fuse box. Could this have damaged control board? Looks ok visually?? Any ideas? Machine is only 18 months old.

    October 8, 2008 at 10:01 am #264541
    iadom
    Moderator

    Re: Indesit IDL530UK2 No Heat -Dishwasher

    Both module and heater are very prone to failure on these machines.

    Are you sure about that model number, I can see an IDL530UK and an IDL535UK.2 but no 530UK.2 ?

    Jim.

    October 13, 2008 at 11:09 am #264542
    Latham63
    Participant

    Re: Indesit IDL530UK2 No Heat -Dishwasher

    Known error codes,page 2? by Lotusray? Cant seem to find this info,any clues regarding fault?

    October 13, 2008 at 2:43 pm #264543
    iadom
    Moderator

    Re: Indesit IDL530UK2 No Heat -Dishwasher

    iadom wrote:Both module and heater are very prone to failure on these machines.

    ERR, I would have thought that was a pretty good clue. 😉


    Copied from Known Error codes thread page two, post by lotusray.

    dishwasher fault codes with bit 100 pcb(written on serial no)
    led1=overflow water in base
    led2=inlet valve
    led3=thermister
    led4=timeout heating
    1+2timeout draining. EDIT 1+2 can also be Software recognition error.
    2+3timeout filling
    1+3filters blocked
    1+4software error
    2+4heater
    3+4timer hardware

    For dishwashers with 7 Led’s (BFI 68 etc ) read Led’s 4 to 7 as code numbers 1 to 4. ie; 4 = 1, 5 = 2 etc.

    October 14, 2008 at 8:15 am #264544
    Latham63
    Participant

    Re: Indesit IDL530UK2 No Heat -Dishwasher

    Thanks,turned out to be mod. Sometimes ya cant see wood for trees.Occasionally the trees go missing?!

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.