Induction hob

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Induction hob

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 19, 2008 at 12:30 pm #40321
    cab
    Participant

    Hi all, Ive got a DeDietrich hob model DTI704, customer complaint is that the two right rings stopped working and F came up beside both on/off touch pads. It has reset itself after a period. Customer was using the back right whilst using the worktop to the right of the front right hob.

    Any ideas?

    October 25, 2008 at 11:28 am #265774
    PlanB
    Participant

    cab wrote:Hi all, Ive got a DeDietrich hob model DTI704, customer complaint is that the two right rings stopped working and F came up beside both on/off touch pads. It has reset itself after a period. Customer was using the back right whilst using the worktop to the right of the front right hob.

    Any ideas?

    May be the same as microwave keypads, liquid spilt on them, or even over use of spray cleaner wicks into the membranes and often causes an error that disappears after a day or so

    October 25, 2008 at 5:26 pm #265775
    Phidom
    Participant

    Re: Induction hob

    If it’s like the AEG hob there are 2 driver modules which power 2 rings each. If something overheated on one of the modules the diagnostic circuitry would shut off those 2 rings. I think the touch controls work on light reflected off your finger rather than using a membrane.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.