Hotpoint WD440

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WD440

Viewing 12 posts - 1 through 12 (of 12 total)
  • Author
    Posts
  • October 19, 2008 at 1:41 pm #40323
    waters
    Participant

    Error 2nd and 4th lights.Replaced pressure switch.
    Still on dry cycle i get this error and machine has suddenly filled with water

    October 19, 2008 at 1:52 pm #265776
    helo_75
    Participant

    you might want to check the sump filter/pump

    its f05

    commonly, not emptying, pressure switch stuck on full!!!

    October 19, 2008 at 3:03 pm #265777
    waters
    Participant

    Re: Hotpoint WD440

    I changed pressure switch.It does full wash ok and dries fine for so long then lights flash and when i open door the drum has 6 inches of water in it

    October 19, 2008 at 3:13 pm #265778
    helo_75
    Participant

    because the pumps blocked!!!

    October 19, 2008 at 6:37 pm #265779
    waters
    Participant

    Re: Hotpoint WD440

    No pump block.Machine works perfect on washes,this only happens on dry

    October 19, 2008 at 6:58 pm #265780
    helo_75
    Participant

    ok
    fine
    .

    October 19, 2008 at 7:16 pm #265781
    timdowning
    Participant

    Re: Hotpoint WD440

    Stick a new pump in it. Could be cutting in an and out. Other than that it must be a strange module fault.

    October 19, 2008 at 7:39 pm #265782
    waters
    Participant

    Re: Hotpoint WD440

    Thanks for help,i will replace the pump to be sure.When the fault occurs i stick it to spin and it drains and spins but will change pump and if not scrap

    October 19, 2008 at 7:47 pm #265783
    Penguin45
    Participant

    Re: Hotpoint WD440

    Flow restictor blown out of condenser inlet valve?

    Chris.

    October 20, 2008 at 3:13 pm #265784
    waters
    Participant

    Re: Hotpoint WD440

    Changed the 3 cold inlet valves and the machine went through a complete cycle ok.The clothes were rather damp though after 90 minutes drying.

    October 20, 2008 at 3:40 pm #265785
    Martin
    Participant

    Re: Hotpoint WD440

    Replace the pump and while you’re at it take the ball valve out of the sump and clean it thoroughly. If the lady is using that Ecover gunk chances are the ball valve sticks as the drum heats up blocking the outflow of water. 😉

    October 20, 2008 at 3:52 pm #265786
    timdowning
    Participant

    Re: Hotpoint WD440

    and if not scrap

    What about the 5 years parts cover?

    😉

    😆

    I’ll get my coat!!!!

  • Author
    Posts
Viewing 12 posts - 1 through 12 (of 12 total)
  • You must be logged in to reply to this topic.