ISE5v2

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ISE5v2

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 22, 2008 at 4:22 pm #40410
    timdowning
    Participant

    Anyone had an error 8 fault yet on the ISE5v2?

    Had one today which seems to be intermittantly stopping with E08.

    Once reset the programme may or may not go right through.

    I have checked all the wiring, tightened connections and tested accordingly. All fine for me.

    Any thoughts as the customer is phoning later tonight with the results
    of her next batch of washing.

    Cheers

    Tim.

    October 22, 2008 at 5:30 pm #266101
    Del
    Moderator

    Re: ISE5v2

    Hi Tim,

    Check motor connections and the short harness plugs (from motor to inverter board ) are fully pushed home.

    HTH

    Sean

    October 22, 2008 at 5:47 pm #266102
    timdowning
    Participant

    Re: ISE5v2

    I wrote;

    I have checked all the wiring, tightened connections and tested accordingly. All fine for me.

    Sean, I may have sorted it, customer hasn’t phoned back yet.
    I just wanted to know what to advise customer if she does still have a
    problem.

    Would it be the motor at fault? Or the motor pcb?

    Thanks,

    Tim.

    November 3, 2008 at 7:03 pm #266103
    timdowning
    Participant

    Re: ISE5v2

    Update:

    Fitted new motor and invertor board 7 days ago. Rang customer today and all is well.

    It will be interesting to find out which part was at fault once I get parts back to Sean.

    Changing the invertor board was easy, the motor was a different story. Getting the four torx screws out was no problem. It was ‘teasing’ the motor off the mounts that was difficult.

    Anyway job done.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.